Ultimaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Has NO ONE any experience of a Volcano on an Ultimaker 2 !?!
The PID Autotune overshoots and shuts down even at a target of 100c yet when I heatup the nozzle to 100c it goes to 140 and then settles down to plus or minus a few degrees.
Doing a manual tune following various links doen't work either.
Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.
They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access.
Ready? Register your product here in just 60 seconds.
Recommended Posts
savak001 0
Has NO ONE any experience of a Volcano on an Ultimaker 2 !?!
The PID Autotune overshoots and shuts down even at a target of 100c yet when I heatup the nozzle to 100c it goes to 140 and then settles down to plus or minus a few degrees.
Doing a manual tune following various links doen't work either.
Any Ideas on setting or what to do?
Regards
Link to post
Share on other sites