UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Has NO ONE any experience of a Volcano on an Ultimaker 2 !?!
The PID Autotune overshoots and shuts down even at a target of 100c yet when I heatup the nozzle to 100c it goes to 140 and then settles down to plus or minus a few degrees.
Doing a manual tune following various links doen't work either.
In the Cura 5.8 stable release, everyone can now tune their Z seams to look better than ever. Method series users get access to new material profiles, and the base Method model now has a printer profile, meaning the whole Method series is now supported in Cura!
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
Recommended Posts
savak001 0
Has NO ONE any experience of a Volcano on an Ultimaker 2 !?!
The PID Autotune overshoots and shuts down even at a target of 100c yet when I heatup the nozzle to 100c it goes to 140 and then settles down to plus or minus a few degrees.
Doing a manual tune following various links doen't work either.
Any Ideas on setting or what to do?
Regards
Link to post
Share on other sites