Jump to content

DSM - Arnitel ID 2060 HT


Recommended Posts

Posted · DSM - Arnitel ID 2060 HT

DSM makes Arnitel ID 2060 HT available to Ultimaker users via our material alliance in Cura. 
You can access all available materials via Cura > Marketplace > Materials. 


Are you curious about others experiences using Arnitel ID 2060 HT or do you have any other questions regarding this filament? Feel free to post them below. 


Some links you might find useful:
Technical Data Sheet
Safety Data Sheet
Printing Guidelines

  • Link to post
    Share on other sites

    • 2 years later...
    Posted · DSM - Arnitel ID 2060 HT

    Hi @JBTechnology83, thank you for your message and welcome to the community! Upon your response I noticed the printing guidelines link didn't work anymore so I updated it, apologies. When you click the new link you will find a pdf that will tell you:


    'Best adhesion with Arnitel® ID is established using an PEI sheet. Alternatively, double adhesive tape or film can be used as well. Larger footprint by adding a brim of at least 5 mm to the print helps adhesion and prevention of warpage.'


    We have a film that can be used; called adhesion sheets. You can find a support article about it here (although it is for UM3, instructions for an UMS5 would be similar). You should be able to find adhesion sheets with our resellers, hope this helps! 

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • UltiMaker Cura 5.7 stable released
        Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more. 
          • Like
        • 16 replies
      • S-Line Firmware 8.3.0 was released Nov. 20th on the "Latest" firmware branch.
        (Sorry, was out of office when this released)

        This update is for...
        All UltiMaker S series  
        New features
        Temperature status. During print preparation, the temperatures of the print cores and build plate will be shown on the display. This gives a better indication of the progress and remaining wait time. Save log files in paused state. It is now possible to save the printer's log files to USB if the currently active print job is paused. Previously, the Dump logs to USB option was only enabled if the printer was in idle state. Confirm print removal via Digital Factory. If the printer is connected to the Digital Factory, it is now possible to confirm the removal of a previous print job via the Digital Factory interface. This is useful in situations where the build plate is clear, but the operator forgot to select Confirm removal on the printer’s display. Visit this page for more information about this feature.
          • Like
        • 0 replies
    • Create New...