UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Not all settings are shown in the panel on the right side, but you can use the search field to find hidden settings or switch to show all settings, which I don't recommend.
When you enable support, then you have a setting available which is called "Enable Support Brim". You can find it, by just enter brim in the search field and you should see the setting in the support section.
Another Cura release has arrived and in this 5.8 beta release, the focus is on improving Z seams, as well as completing support for the full Method series of printers by introducing a profile for the UltiMaker Method.
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
Recommended Posts
Smithy 1,145
Not all settings are shown in the panel on the right side, but you can use the search field to find hidden settings or switch to show all settings, which I don't recommend.
When you enable support, then you have a setting available which is called "Enable Support Brim". You can find it, by just enter brim in the search field and you should see the setting in the support section.
Link to post
Share on other sites