Jump to content
HaryPlotter

Blobs and stringing (but only from one side)...

Recommended Posts

Posted · Blobs and stringing (but only from one side)...

Dear Community,

 

at first probably there is to say that I had to reinstall my Password as my old nick was somehow eliminated... so that is done now! Strange but true...

 

Now to my problem. Since a few weeks I am experiencing a rather strange kind of problem. I have a stringing and blopping-problem on the prints. BUT ONLY ON ONE SIDE... I left some fotos of the actual print for you so you can see the difference from one side to the other...

 

I don´t know with parameter to tweek here as the problem does not seem to be equally distributed. Anyhow I tried the ususal things like retraction speed z-hop and so on but there is no real improvement. And it never happened before. Filament is the same (CF-20). I use a special non abbrasive rubi.nozzle for it..

 

So if anybody has any idea what kind of problem causes this I would be very happy.

 

Greetings

 

 

 

Daniel

20190313_154915.jpg

20190313_154906.jpg

20190313_154910.jpg

20190313_154920.jpg

Setup1.jpg

Setup II.jpg

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!