Jump to content
Ultimaker Community of 3D Printing Experts

Clay 3D Printer


Recommended Posts

Posted · Clay 3D Printer



I'm building a Clay 3D printer from scratches. As a controller I used a TinyG, and Coolterm to comunicate with it.

I wanted to use CURA to develope the Gcode, because this is the software I use normally as a slicer for my 3D printers.

I have had the following problem:


When I set the gcode flavor, all of them have the extruder axis named with an E, but my controller reads it with an A. Is there ayway to change this name?


Thanks you!

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now

    • Our picks

      • New here? Get ahead with a free onboarding course
        Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
        Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.   
        They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access. 
        Ready? Register your product here in just 60 seconds.
          • Like
        • 11 replies
    • Create New...