UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
There are several possibilities. The most likely is a slipping pulley. Try pushing the head in Y direction and make sure the Y stepper is moving. If not tighten all the set screws.
Next the stepper driver. I would swap the printer driver for X and Y. Google about these and where they are located. Remove them very very carefully by prying one side, then the other, then back to the first side. You don't want to bend the pins. Also insert very carefully and examine them to make sure none of the pins bent when you did it.
It's actually quite easy to do if you are patient and have a tool (like a small screwdriver) that can gently pry off the stepper driver. These are also called "pololu" so if you are googling about the stepper drivers you could check for that instead of "stepper driver".
Always add and remove these while power is off.
You can run these for a few seconds with no fan but if anything gets hot it's time to cut power and put the fan on. Particularly that one part that sticks up the most. That gets hot first.
Lastly the stepper itself or the cabling. I doubt it is these though. But if so, the problem will stay with the X when you swap drivers.
Link to post
Share on other sites
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
In the Cura 5.8 stable release, everyone can now tune their Z seams to look better than ever. Method series users get access to new material profiles, and the base Method model now has a printer profile, meaning the whole Method series is now supported in Cura!
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
Recommended Posts
gr5 2,224
There are several possibilities. The most likely is a slipping pulley. Try pushing the head in Y direction and make sure the Y stepper is moving. If not tighten all the set screws.
Next the stepper driver. I would swap the printer driver for X and Y. Google about these and where they are located. Remove them very very carefully by prying one side, then the other, then back to the first side. You don't want to bend the pins. Also insert very carefully and examine them to make sure none of the pins bent when you did it.
It's actually quite easy to do if you are patient and have a tool (like a small screwdriver) that can gently pry off the stepper driver. These are also called "pololu" so if you are googling about the stepper drivers you could check for that instead of "stepper driver".
Always add and remove these while power is off.
You can run these for a few seconds with no fan but if anything gets hot it's time to cut power and put the fan on. Particularly that one part that sticks up the most. That gets hot first.
Lastly the stepper itself or the cabling. I doubt it is these though. But if so, the problem will stay with the X when you swap drivers.
Link to post
Share on other sites