Jump to content

Something weird with my printer


abusuioc

Recommended Posts

Posted · Something weird with my printer

In last print job Ultimaker 2+ has shut down after 75% of printing, second time has stopped but with nozzle heated and last time after 1 hour again printer has shut down after 1 hour of printing.

  • Link to post
    Share on other sites

    Posted · Something weird with my printer

    Not an expert but I would guess some issue with the power supply or heater/pt100 sensor.

     

    Can you try with another power supply? (Do you have more than one UM2 or can borrow one?)

     

    For the heater and the PT100 temperature sensor you can check if they are ok by measuring there resistance with an ohm. Meter. The PT100 should be about 108 ohm at room temp, the heater I’m not sure but can check later if needed. And if you do the above you need to disconnect them from the main board, also check if the connectors are tight, if not this is probably already the issue...

     

     

  • Link to post
    Share on other sites

    Posted · Something weird with my printer
    1 minute ago, ultiarjan said:

    Not an expert but I would guess some issue with the power supply or heater/pt100 sensor.

     

    Can you try with another power supply? (Do you have more than one UM2 or can borrow one?)

     

    For the heater and the PT100 temperature sensor you can check if they are ok by measuring there resistance with an ohm. Meter. The PT100 should be about 108 ohm at room temp, the heater I’m not sure but can check later if needed. And if you do the above you need to disconnect them from the main board, also check if the connectors are tight, if not this is probably already the issue...

     

     

    Thanks for advise....unfortunately i cannot open/demount because is still under warranty.  Already i call the dealership. 

     

    The only thing what i can do i will try different model to print. i tried 3rd times on same model and was stopped in same X/Y but different Z.

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • UltiMaker Cura 5.8 Stable released 🎉
        In the Cura 5.8 stable release, everyone can now tune their Z seams to look better than ever. Method series users get access to new material profiles, and the base Method model now has a printer profile, meaning the whole Method series is now supported in Cura!
        • 5 replies
      • Introducing the UltiMaker Factor 4
        We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
          • Thanks
          • Like
        • 3 replies
    ×
    ×
    • Create New...