Jump to content

y values don't match between scaling and dimensions


Recommended Posts

Posted (edited) · y values don't match between scaling and dimensions

I've got a model which I have scaled in Cura, on the scaling panel it says y=57.6268 but in the lower left corner of the main panel, below the filename, it has y=62.6 under Cura 4.3, the same model scaled to the same values in the scaling panel has y=59.9 in the lower left.  Is there a reason x and z would match with the scaling panel while y doesn't match?  And why would y be different between the two version of Cura?  Thanks in advance for any enlightenment you can offer!


Edit: Never mind, it was due to a support blocker block that extended y, and since I added those manually they were different under the two versions of Cura.  Is there a way to delete this post?

Edited by LindsayPatten
Found reason myself
  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • UltiMaker Cura 5.7 stable released
        Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more. 
          • Like
        • 7 replies
      • S-Line Firmware 8.3.0 was released Nov. 20th on the "Latest" firmware branch.
        (Sorry, was out of office when this released)

        This update is for...
        All UltiMaker S series  
        New features
        Temperature status. During print preparation, the temperatures of the print cores and build plate will be shown on the display. This gives a better indication of the progress and remaining wait time. Save log files in paused state. It is now possible to save the printer's log files to USB if the currently active print job is paused. Previously, the Dump logs to USB option was only enabled if the printer was in idle state. Confirm print removal via Digital Factory. If the printer is connected to the Digital Factory, it is now possible to confirm the removal of a previous print job via the Digital Factory interface. This is useful in situations where the build plate is clear, but the operator forgot to select Confirm removal on the printer’s display. Visit this page for more information about this feature.
        • 0 replies
    • Create New...