Jump to content
Sign in to follow this  

Cura 13.10 Mac

Recommended Posts

Posted · Cura 13.10 Mac

There's a 'cut off bottom' setting in the advanced tab. Is that set to something other than zero?

If not, are your STL's from any particular source program?


Share this post

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!