Jump to content

Ultimaker 2, bed temp error issue


Viggoman

Recommended Posts

Posted · Ultimaker 2, bed temp error issue

I'm experiencing  a bed temp error message after e few minutes of printing. It seems to happen at more or less the same spot every time.

 

Recycling the power clears the error, but it repeats after a few minutes.

 

I have had a bed temp issue a few month back and followed the trouble shooting instructions, even replaced the main board. But it wasn't until I checked the wire connector at the bed it got solved.

 

I have tried this out again to no avail. 

 

Any tips tracing the culprit of this?

 

Thanks

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • UltiMaker Cura 5.4 stable released
        The full stable release of UltiMaker Cura 5.4 is here and it makes it easier than ever to remove brims and supports from your finished prints. UltiMaker S series users can also look forward to print profiles for our newest UltiMaker PET CF composite material!
          • Like
        • 58 replies
    ×
    ×
    • Create New...