Jump to content

Temp Sensor problem - some clarification needed


cigoler

Recommended Posts

Posted · Temp Sensor problem - some clarification needed

I've followed the instruction from here; https://ultimaker.com/en/resources/19484-stopped-temp-sensor following a problem when starting prints of a temp sensor problem. So i've swapped Temp 1 and Temp 3 and heating the bed doesn't bring up an error - but it also doesn't increase the temperature of the bed it stays stuck at 27 degrees. When I then try heating up the nozzle I get bed temperature error.

 

The instructions aren't super clear about this. Does it mean it's the sensors fault or the main board?

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • UltiMaker Cura 5.8 Stable released 🎉
        In the Cura 5.8 stable release, everyone can now tune their Z seams to look better than ever. Method series users get access to new material profiles, and the base Method model now has a printer profile, meaning the whole Method series is now supported in Cura!
        • 5 replies
      • Introducing the UltiMaker Factor 4
        We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
          • Thanks
          • Like
        • 3 replies
    ×
    ×
    • Create New...