Retraction Minimum Travel

[2go 6]

Hello!

 

Ultimaker 2+.

 

Upgraded from Cura 3.4.1 to 4.4.1.

 

In 3.4.1 setting 'Retraction Minimum Travel' was visible. In 4.4.1 it is hidden with a message 'This setting has been hidden by the active machine and will not be visible'.

 

Not being able to change the default value increases printing time for the type of things I print by roughly 20% without any visible benefit. Is there a way to change it without going back to an older version of Cura? Thank you.

[2go 6]

Alright, found some info here: https://github.com/Ultimaker/Cura/issues/6513 and here https://github.com/Ultimaker/CuraEngine/pull/1108 -- fingers crossed it gets fixed in the next release. Reverted to Cura 3.6 for now.