Overhang at the bottom of the print

[Tarkahn 2]

I've included picture.  After I installed the newest version of Cura (4.4.1)  I now get an overhang at the bottom layer where it should be flat with the build-plate.  This has never been an issue until I just today installed the newest version.  I assumed the print would automatically touch the buildplate - Is there a trick to getting this back the way it used to be?

 

You can see from the image that I'm testing this out by printing some flat plates - I've searched the forums but have not been able to find an answer to this specific problem.

 

I'm printing with an Ultimaker 2

 

Thanks for any help - I appreciate it very much!

[Tarkahn 2]

Update:  As a test I installed a prior version and unfortunately the overhang on the bottom layer persists.  grrrr

[Tarkahn 2]

I have also attemted to update the firmware on my ultimaker 2 - it is now version 3.3.0