You may put some screenshots of this? it was better anyway..
- Guest changed the title to Hello, I need help with slicing
![Guest maht](http://content.invisioncic.com/ultimake/set_resources_16/84c1e40ea0e759e3f1505eb1788ddf3c_default_photo.png)
Guest maht
There's a manual here https://ultimaker.com/en/resources/52887-welcome-to-ultimaker-cura
You may put some screenshots of this? it was better anyway..
There's a manual here https://ultimaker.com/en/resources/52887-welcome-to-ultimaker-cura
Recommended Posts
Oliveros 11
You shouldn't have to input any G-code, you just load your model into cura and set your settings and export it as a G-code file for the printer.
Link to post
Share on other sites