Jump to content
Ultimaker Community of 3D Printing Experts

CURA 4.5 What the heck is this?


Recommended Posts

Posted (edited) · CURA 4.5 What the heck is this?

I recently updated from 4.2 to 4.5. I'm now experiencing reeeeeeeallly long slice times when tree support is enabled and I'm also seeing these purple line artifacts. What could be going on here?

 

image.thumb.png.802af3c85ad8f0475932494b0578ebd9.png

Edited by batesman
  • Link to post
    Share on other sites
    Posted · CURA 4.5 What the heck is this?

    You say the long slice times are only when you have tree support enabled?

     

    Are you sure that tree support didn't always take a lot longer to slice?

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    ×
    ×
    • Create New...