Jump to content

Recommended Posts

Posted · Cura 4.5 wall issue

Just trying to move from simplify3d to cura and have couple issue. So far all good experience, but one of issues is when after infill starting printing walls inside no retracting happens but nozzle starts moving very fast and blobbing instead of nice print until it slowing down to print same line and finishing nice line. that creates small blobs of filament and that filament sticks to nozzle and get dragged around print.

Second one is if any circle in the middle of the print no retraction happens then it does move from one to another location leaving lines. not so important inside of print but not nice then that happens top or bottom layers.

 

Other wise getting half decent print. 🙂

IMG_3608.jpg

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • UltiMaker Cura 5.9 stable released!
        Here comes Cura 5.9 and in this stable release we have lots of material and printer profiles for UltiMaker printers, including the newly released Sketch Sprint. Additionally, scarf seams have been introduced alongside even more print settings and improvements.  Check out the rest of this article to find out the details on all of that and more
          • Like
        • 5 replies
      • Introducing the UltiMaker Factor 4
        We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
          • Heart
          • Thanks
          • Like
        • 4 replies
    ×
    ×
    • Create New...