Jump to content
UltiMaker Community of 3D Printing Experts

Scratches in linear rods


Recommended Posts

Posted (edited) · Scratches in linear rods


 i have noticed the 10mm rods on my S5 have slight scratches in them. If i run my nail over them i can feel they are actually grooved slightly into the rod. I thought these were hardened rods ?, anyone else noticed this, they aren't particularly deep at moment but still i wasn't expecting to see any marks on them, maybe i just never noticed them on my 2+. I always keep the rods well oiled with the supplied thin oil.



Edited by Link
  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now

    • Our picks

      • New here? Get ahead with a free onboarding course
        Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
        Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.   
        They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access. 
        Ready? Register your product here in just 60 seconds.
          • Like
        • 14 replies
    • Create New...