UTM 2+ Copper Fill

[curnow98100 0]

Hi All,

 

I am about to purchase a Ultimaker 2+ and was wondering what else I need to purchase to be able to print Formfutra Copper Fill?

 

Thanks

[Carla_Birch 116]

Hi,

With copper fill filaments, they are hard wearing on the nozzles and feeders. Also it’s better for most to use a 0.5 nozzle due to the little bits inside the filament they can block a 0.4

 

If you plan to print with it a lot I would look at getting hardened nozzles and also feeders.

 

If you only going use it now and then then you should get away with just a 0.5 nozzle, but keep in mind a brass one will wear faster using copper fill.

Edited July 3, 2020 by Carla_Birch