Settings causing the outer layer not to print?

[Mogwaisix 0]

Any ideas which settings are causing this difference in a print 0.1 super fine. One is my custom the other is the cura standard. I cannot for the life of me figure out why. Same STL file

The cura standard one is perfect mine is not. 

 

[burtoogle 515]

The gap is caused by coasting being enabled.

[Mogwaisix 0]

You are a legend thank you. Saved me going through every setting to compare.

I am going to print 2 of the same to see if they are very different

 

 

Edited July 13, 2020 by Mogwaisix