Jump to content

Ultimaker 3 doesnt print fully on some Z layers.

Ludmasson76

By Ludmasson76
in Improve your 3D prints

 Share

Recommended Posts

Ludmasson76

Ludmasson76 0

Posted
Posted (edited) · Ultimaker 3 doesnt print fully on some Z layers.

So I have been having a problem with the Ultimaker not printing fully on some of the Z layers. I literally have tried everything that I could find info on for Z related problems. I have cleaned the Z lead screw and bearings, I have cleaning out the motor that pulls the filaments, I have tried slowing down the feed rate of extrusion, I have check all belts. I have tried different models and different filaments. I am lost and cannot figure out how to fix this issue. With printing the same model it happens in different Z locations

 

With the picture provided, it will print perfect then all of a sudden not full print out  Z layers, then it will go back to printing good and then back to missing Z info. 

 

Does anyone have any advice or have dealt with this problem.

 

Thanks

Jasper

 

20200806_141056.thumb.jpg.66325a4978d64c5d5754196eb0b18137.jpg

 

 

Edited by Ludmasson76
    • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share
    Go to topic listing

    • Our picks

      • UltiMaker Cura 5.7 stable released

        UltiMaker Cura 5.7 stable released

        ArunC posted a topic in UltiMaker Cura,

        Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more. 
         
          • Like
        • 16 replies
        MariMakes

        Picked By

        MariMakes,

      • Release Notes: S-Line Firmware 8.3.0 (Latest)

        Dustin posted a topic in Firmware,

        S-Line Firmware 8.3.0 was released Nov. 20th on the "Latest" firmware branch.
        (Sorry, was out of office when this released)

        This update is for...
        All UltiMaker S series  
        New features
         
        Temperature status. During print preparation, the temperatures of the print cores and build plate will be shown on the display. This gives a better indication of the progress and remaining wait time. Save log files in paused state. It is now possible to save the printer's log files to USB if the currently active print job is paused. Previously, the Dump logs to USB option was only enabled if the printer was in idle state. Confirm print removal via Digital Factory. If the printer is connected to the Digital Factory, it is now possible to confirm the removal of a previous print job via the Digital Factory interface. This is useful in situations where the build plate is clear, but the operator forgot to select Confirm removal on the printer’s display. Visit this page for more information about this feature.
          • Like
        • 0 replies
        MariMakes

        Picked By

        MariMakes,
      View All
    ×
    ×
    • Create New...