Thickness Below 3mm no infill, solid fill

[dlum0612 0]

Hi All,

 

I am printing a character from a video game that is quite big. He is holding a weapon and the handle of the weapon gets pretty thin. Is there a setting within cura to make it so that the entire print has infill except for areas that are very thin like the handle (specify less than 3 mm) where it'll make the handle part solid and print the rest of the part with infill? Attached is a picture of the cross section of the handle. Right now it will print with 3 walls and some infill. I'd rather it just be solid here, but have the rest of the print have infill.

 

 

Thanks

Edited August 11, 2020 by dlum0612

[nallath 1,124]

You could increase the number of walls or go for the more labour intensive option of using modifier meshes.