Raft configuration issues on new install of cura 4.8

[cchisholm 0]

I’ve been using cura 4.7.2 for a while, but started having issues with the computer.  I installed the latest (4.8) and started having problems with the raft being difficult to remove.  Unfortunatly I don’t know how the previous version was configured.  
 

Question: what raft setting should I be looking at relative to the model adhesion to the raft.  I have tweaked a few but none have helped thus far.  
 

Also, I had managed it get two layer raft with 4.7.2 but can’t get less than three with 4.8.   I am well aware that this is a user deficient, not a software problem.

 

Thank,

Charlie