-
Our picks
-
Introducing the UltiMaker Factor 4
ArunC posted a topic in UltiMaker 3D printers,
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications-
- 3 replies
.thumb.jpeg.0b7a05eafc09add17b8338efde5852e9.jpeg)
Picked By
MariMakes, -
-
UltiMaker Cura 5.7 stable released
ArunC posted a topic in UltiMaker Cura,
Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more.
-
-
- 26 replies
Picked By
MariMakes, -
-
.thumb.jpeg.0b7a05eafc09add17b8338efde5852e9.jpeg)
Recommended Posts
zakeen 3
Depending your work environment temp and humanity levels can affect the figment. If it gets too soft sometimes the feeder can not grip it enough. To test the proper way, remove the figment and just check if you have lots of wear at the point just after you feed the figment into the UM. What happens is the figment gets too soft and the feeder can not grip it and it just wears it out at that point. The printer thinks its still feeding through.
To fix this in future you can remove about 3 cm at the end of the current figment, that would make the part that was worn a little past the point of part of the UM that feeds it. Then adjust the tension for it to feed better. Depending on your environment you might have to make it less hard or more easy for it to proper grip. I am talking at the back where you feed the figment into the UM there should be a bolt to adjust and a level meter to see. depending on you UM. I have S2 and S5 and they both have this.
Link to post
Share on other sites