Using random layer start ppsitions

[bman 2]

Is there away to randomize the starting point of new layers in Cura 4.7+?

 

I have been trying to print a small part with delicate overhangs using Peth. The part prints well except the overhang seems to be at the start / endpoint of the layers and as such the hotend stays on it too long melting it is there away to start at another point so this area can have a chance to cool?

 

I am printing slow, have tried the fan on low speed, and used z hop. They help alittle.

 

Thank you

 

 

 

 

 

 

 

[curasurf 4]

Z Seam Alignment = Random

Randomize Infill Start

Layer Start X Layer Start Y

Edited February 23, 2021 by curasurf