creality c10 v3

[snapperob 0]

hi , i have a c1o v3 and want to add a cr touch ,mine has a v2.5 2 board ,

the cr touch i see to buy say they are for a 32 bit board only , will this type work with my board 

[GregValiant 1,351]

If it is an older printer you will need to look at the mainboard and the main chip on the board.  If it is an STM32F1 then it's 32 bit.

I don't think Creality has put an 8 bit board into a printer since last fall.  There should be something on the Creality site to point you in the right direction.  The CR10 forum on Reddit would be a good place to start looking as well.

I just found this...I don't know if it's true but it's the way my boards are:

"Look at the USB connector. If it is a mini USB socket then it is 8 bit. If it is a micro USB socket it is 32 bit."

So the bigger socket means it's 8 bit.

 

This site mostly covers Ultimaker hardware and Cura.  My printer is an Ender 3 Pro but I'm much in the minority here.

Edited September 8, 2021 by GregValiant