Jump to content
Ultimaker Community of 3D Printing Experts

Die Ecken meiner Ausdrucke sind immer überhöht (dicker)


Recommended Posts

Posted · Die Ecken meiner Ausdrucke sind immer überhöht (dicker)

Ich drucke seit einem Monat mit den Drucker "Anycubic i3 Mega X"und die Ergebnisse

haben immer eine Überhöhung an den Ecken der Außenhaut, was zu Maßungenauigkeiten führt. Dieses Phänomen ist für mich

nach unzähligen Ausdrucken über andere Drucker neu! Ich kann es über die Einstellungen nicht schaffen

das zu beheben! Liegt das nun am Drucker oder an den Voreinstellungen bei Ultimaker? Kennt jemand

das Problem und wie kann ich das abstellen?




  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now

    • Our picks

      • Ultimaker showcase | April 2022 | 4pm CEST | 10am EDT
        I'm excited because I've personally produced this showcase event, so if you are curious what else I'm up to nowadays, come check it out and say hi in the chat! It would mean a lot! 
          • Thanks
          • Like
        • 4 replies
      • New here? Get ahead with a free onboarding course
        Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
        Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.   
        They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access. 
        Ready? Register your product here in just 60 seconds.
          • Like
        • 12 replies
    • Create New...