E Sun 2.85 MM water Soluble PVA

[Mvincent777 0]

Hello!  I was wondering if Ultimaker S3 will accept ESun water soluble PVA filament size 2.85 mm?  How do I get it on the marketplace to then add to Cura so that the 3D printer can identify it and print?

Thanks in advance!

[TimonR 21]

Hi @Mvincent777,

I guess you can use the 'generic PVA' material profile and modify the settings in Cura based on eSUNs recommendations.
eSUN is responsible for uploading a profile to the Marketplace and Ultimaker has to approve it, so you can't do that yourself unfortunately.

Pro tip: make sure to keep your PVA dry.

Good luck!