UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
You are not being very specific about what you mean by "got stuck on the spool", so I can only guess the filament somehow got tangled (ie: the filament on the spool somehow got wound under the previous winding, instead of over). This can happen if you are not careful about rewinding the spool when you change materials.
When the printer fully retracts the material from the bowden tube, you can end up with a "jumble" of filament behind the printer. If you just pull that tight, you can create a "knot" in the spool. That knot can sometimes move along with the unwinding of the spool as you print, but eventually it will get tight and cause a failure to pull material into the printer.
Allways keep your spools of filament tought but putting the end of the filament in one of the holes along the brim of the spool, and always carefully rewind the spool after removing it from the printer.
Link to post
Share on other sites
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
In the Cura 5.8 stable release, everyone can now tune their Z seams to look better than ever. Method series users get access to new material profiles, and the base Method model now has a printer profile, meaning the whole Method series is now supported in Cura!
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
Recommended Posts
ahoeben 1,981
You are not being very specific about what you mean by "got stuck on the spool", so I can only guess the filament somehow got tangled (ie: the filament on the spool somehow got wound under the previous winding, instead of over). This can happen if you are not careful about rewinding the spool when you change materials.
When the printer fully retracts the material from the bowden tube, you can end up with a "jumble" of filament behind the printer. If you just pull that tight, you can create a "knot" in the spool. That knot can sometimes move along with the unwinding of the spool as you print, but eventually it will get tight and cause a failure to pull material into the printer.
Allways keep your spools of filament tought but putting the end of the filament in one of the holes along the brim of the spool, and always carefully rewind the spool after removing it from the printer.
Link to post
Share on other sites