UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Load the model into Cura and adjust you settings the way you want. The use the "File | Save Project" command and post the resulting 3mf file here.
I'm assuming this is a single wall model. This can be a hard one to nail down as it is almost always a function of the amount of oozing that the nozzle is doing during the travel move between the last extrusion, and the next one. Sometimes you need to rotate the model, other times rotating the infill (line directions) can help. Limiting the travel between the end of one extrusion and the start of another is a key.
If you had retraction turned on then you might consider adjusting "Retraction Extra Prime Amount".
There is a post-processor for "Retract Continue" that does a slow retraction over a distance, but again, you have to have retraction enabled and I seem to recall that the plugin is confused by Zhops.
Under "Travel" there are boxes for the layer start position. You may be able to adjust them and move the start to the Zseam position. Combing is another adjustment.
In the Cura preview - turn off the Shell and Infill and turn on "Travel Moves".
Link to post
Share on other sites
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
In the Cura 5.8 stable release, everyone can now tune their Z seams to look better than ever. Method series users get access to new material profiles, and the base Method model now has a printer profile, meaning the whole Method series is now supported in Cura!
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
Recommended Posts
GregValiant 1,342
Load the model into Cura and adjust you settings the way you want. The use the "File | Save Project" command and post the resulting 3mf file here.
I'm assuming this is a single wall model. This can be a hard one to nail down as it is almost always a function of the amount of oozing that the nozzle is doing during the travel move between the last extrusion, and the next one. Sometimes you need to rotate the model, other times rotating the infill (line directions) can help. Limiting the travel between the end of one extrusion and the start of another is a key.
If you had retraction turned on then you might consider adjusting "Retraction Extra Prime Amount".
There is a post-processor for "Retract Continue" that does a slow retraction over a distance, but again, you have to have retraction enabled and I seem to recall that the plugin is confused by Zhops.
Under "Travel" there are boxes for the layer start position. You may be able to adjust them and move the start to the Zseam position. Combing is another adjustment.
In the Cura preview - turn off the Shell and Infill and turn on "Travel Moves".
Link to post
Share on other sites