Why when i star printing it wants to go further left and further front, jumping steps and grinding my belts?
Check your min endstops!
Most startup gcode tells the firmware to move until it hits the X, Y and Z endstops then sets that position to -120/-120/0. If it is moving to the front/left of the printer then not stopping, it means that the firmware is not seeing the endstops trigger..
Recommended Posts
italianmaxx 0
After the gazillionth reading of this forum I found that NF use a 100,100 home ( fixed and not moveable nor resetable i guess) . So the head WANT to go home before starting print ( actually i unchecked the flag on the Machine-Ultimaker-... button but it doesn't seem to make any difference) and after that the head wants to go back-left for preheat (?). Then it goes to center and start printing.
So maybe this is a correct netfabb workflow?
1. Load parts/ stl
2. Decide profiles
3. Slice ang get gcode
4. Position the head at 0,0,0 ( front/left corner with the base Z height ready to print)
5. Start printing
At this moment nf should stay at home, go to back left and preheat then go center and print.
Why when i star printing it wants to go further left and further front, jumping steps and grinding my belts?
Please if someone have a correct nf workflow with correct extruder head positioning before the print, let me know.
Thanks
Link to post
Share on other sites