McAffee & Cura 5.0.0-Beta+1

[Kraig777 0]

Cura software, version 5.0.0-beta+1, gets quarantined by my McAffee anti-virus software.  I just noticed this when the executable mysteriously disappeared.  I restored it; but, it keeps getting quarantined again later.

 

I thought this was something folks should know about.  I also would like to know if someone has a solution to this problem.

 

 

 

Kraig777

[NeilSM 0]

I am getting the same with Cura 5.0.

There is some information on the support pages about it being the recently updated icon. As MacAfee has flagged the executable I'm sitting tight and not bypassing the antivirus until the issue is resolved.

[DFief 0]

Same thing happened to me today.  I used it just fine from release date until yesterday.  Now, today it is quarantined.

 

Any help on the way?

 

Don

[Brona0988 0]

5.0 was working fine when I first downloaded it. Much better than the other versions in my opinion. However, my virus scanner started scanning and quarantining it. I attempted to put it in an excluded status, but it still quarantined it. I've had to turn off my active scanning in order to run it. Now having issues with 5.0+beta+01. It's acting as if it's loading the first time, and I have to add my printer's all over again. When it does finally boot up it will show my other printers. Cura is my preferred slicer, but I'm having to use another slicer until the issues are resolved.