UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
In CURA 5 I think "Fill gaps between walls" is always set to "on" and "Filter out tiny gaps" set to "off" & both options have been removed from print settings. However I would really like them added back and be be able to choose like I did in previous versions of CURA whether or not I want to fill or not to fill small gaps. I some times print with a really large nozzle (1.5mm) and feel I get better print quality with these little droplets omitted.
Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more.
S-Line Firmware 8.3.0 was released Nov. 20th on the "Latest" firmware branch.
(Sorry, was out of office when this released)
This update is for...
All UltiMaker S series
New features
Temperature status. During print preparation, the temperatures of the print cores and build plate will be shown on the display. This gives a better indication of the progress and remaining wait time. Save log files in paused state. It is now possible to save the printer's log files to USB if the currently active print job is paused. Previously, the Dump logs to USB option was only enabled if the printer was in idle state. Confirm print removal via Digital Factory. If the printer is connected to the Digital Factory, it is now possible to confirm the removal of a previous print job via the Digital Factory interface. This is useful in situations where the build plate is clear, but the operator forgot to select Confirm removal on the printer’s display. Visit this page for more information about this feature.
Recommended Posts
OPC 2
In CURA 5 I think "Fill gaps between walls" is always set to "on" and "Filter out tiny gaps" set to "off" & both options have been removed from print settings. However I would really like them added back and be be able to choose like I did in previous versions of CURA whether or not I want to fill or not to fill small gaps. I some times print with a really large nozzle (1.5mm) and feel I get better print quality with these little droplets omitted.
https://support.ultimaker.com/hc/en-us/articles/4792349488668-What-print-settings-have-been-removed-from-Cura-5-
Link to post
Share on other sites
calisson13 0
Hello everybody !
Edited by calisson13I think you might want to look at "wall transition length" and "wall distribution count" and other parameters begining with "wall transition..." or "wall something" that I think were added in cura 5. I am discovering these right now. I will probably be using them in cura or luban as I often print very small and precise models.
https://github.com/Ghostkeeper/SettingsGuide/blob/master/resources/articles/shell/wall_distribution_count.md
https://github.com/Ghostkeeper/SettingsGuide/blob/master/resources/articles/shell/wall_transition_angle.md
Don't discourage ! 😉 (I sometimes do)
Link to post
Share on other sites