ah :mrgreen:
thanks!
i've put them on our 3d prints collection site
http://www.duizend-dingen.nl/?page_id=154
-
1
ah :mrgreen:
thanks!
i've put them on our 3d prints collection site
http://www.duizend-dingen.nl/?page_id=154
Recommended Posts
gr5 2,224
I don't know but you can figure it out in seconds:
1) load a tiny STL file.
2) select "fast low quality print"
3) Save the gcode (or save the settings profile)
4) Switch non quickprint mode
You would think at this point it would show the previous settings but it doesn't.
5) in file menu, load the profile you saved or do "load profile from gcode".
now all the settings visible are from the quickprint fast low quality mode
Another setting you should change for most (all?) prints is to enable retraction.
Link to post
Share on other sites