Layer ends move upwards on layer change

[tryptamine 3]

 

I do not understand why on some prints, the layers deform upwards where the z seam is. on other prints, this is not the case:

 

even though this little thing was printed at very high speeds.

 

 

 

The first print is simply a cylinder, the 3MF here:
LayerUpwards.3mf

 

My configuration here:
BugLayer.curaprofile

 

I played around with Wipe Distances and Coasting but i simply can not resolve this.

Any idea which setting in my profile could be causing this? 

Printed on a Hypercube Evolution with Bowden setup.