GregValiant 1,342
You have at least two post processors running. Did you print a temp tower recently?
Cura does not directly add the lines in bold below. They are from at least one post-processor. Since the second M117 line immediately erases the first M117 from the LCD screen I'm guessing at least two post processors. The temperature lines may be from a third and the fan line might be from a fourth.
Are you using OctoPrint?
M117 INDICATOR-Layer5
M117 DASHBOARD_LAYER_INDICATOR 6
;TYPE:CUSTOM LAYER
M104 S220
M106 S182.1
;TYPE:WALL-INNER
;MESH:Body1.stl
Recommended Posts
Mcudnic 0
go to material and then click the up top left box ,and check those boxes initial temp and so on. Then you have control over everything. Because the are occasions you need to tweak them. Ran into the same issue! I cannot take pics of this.if you check the boxes it will show the next time you on the the material settings menu
Edited by McudnicLink to post
Share on other sites