As the OP suggested a video would be adviced or, at least, a revision of the instructions. I've tried to follow your manual (2024) and instructions are all but clear. Pictures do not match steps. And some phrases are difficult to understant, at least for a foreigner.
- 3 months later...
I need to agree with @CarlesCC, instructions are horrible, have used most part of my day trouble shooting why the prints suddenly began to lose quality.
6 hours ago, Geonor said:I need to agree with @CarlesCC, instructions are horrible, have used most part of my day trouble shooting why the prints suddenly began to lose quality.
Did you check the videos offered by Fbrc8?
https://www.youtube.com/@fbrc8/videos
- 3 weeks later...
On 3/28/2025 at 4:00 PM, LePaul said:
Sure, I wonder why there are no official videos like that. We used the one for replacing the belts. That channel is a must if you have an ultimaker.
Nevertheless for regular maintainance I think its better to have a printed manual with steps and instructions at your side: to be sure to forget nothing and you followed all required steps. Thats something a video isn't as good at.
Edited by CarlesCC
Recommended Posts
Dustin 193
If you have already confirmed the pulleys are secured, its possible the belts need replaced.
Maybe you can share a video of what you are seeing on your machine?
Link to post
Share on other sites