PaulKuiper 11
You can download the settings guide plugin for more details/images on the settings.
I would guess this should work:
- Choose combining “not on outer surface” (All also works but takes much longer due to many unnnessesary retracts in infill areas).
- Enable “travel avoid printed parts”
- Enable “z hob when retracted”
- Enable “z hob only over printed parts”
- increase z hop height if needed
There is a known bug in Cura that avoiding parts does not work during a nozzle switch travel move. However based on your photo this does not seem to be the issue.
if that is not enough:
- Set Max comb distance to 1mm (basically always retract)
- Enable a prime tower (to wipe oozed material from the nozzle after a switch)
- make sure the PVA is dry. It appears wet (white color from water bubbles) and this can cause oozing. Same for TPU and Nylon. It needs to be super dry.
-
1
Recommended Posts
Dustin 160
Look for setting: "Combing Mode" and change that.
Link to post
Share on other sites
AEtherScythe 3
Hi, @Dustin. Thank you for that.
I clearly need a little more help with interpreting which option will help me most here.
I am using Combing mode "All" currently.
My Z-Hop settings are based on retraction, so I definitely want retraction to occur over the top layers, but what I was really hoping to achieve is to avoid traveling over printed parts altogether -- would be better to go around the outside, not just for this part but for other work using TPU, where I have some oozing and I don't want the "hairs" being deposited over the top surfaces.
I care about quality, not speed, for this work.
I guess I was hoping for a Combing mode of "Avoid Top Layers" -- I have the "Avoid Printed Parts When Traveling" enabled.
It seems these settings are either in conflict or do not work the way I had expected.
Pretty please could you make a recommendation here?
Link to post
Share on other sites