Gaps in the wall of my cookie cutters!

[meganwilliams125 0]

Help! I'm brand new at 3D printing. I've read through some troubleshooting and fixed several settings in my Ultimaker Cura Program, the cookie cutter keeps getting better and better BUT there are still these little gaps all over in the wall! I found several people with the same problem and they were told to adjust the following: In Walls - change Zseam alignment to shortest, Seam Corner Preference to Hide or Expose Seam, change the Wall Transitioning Threshold Angle to 50 and lastly change Wall Ordering from Outside to Inside. I did all of those and still there are gaps. Ugh, help please!

[MrBeantown 1]

is it like that in the slicer, or is it only after printing?

[meganwilliams125 0]

I think it's like that in the slicer...but I'm not 100% sure how to tell.