All prints pause at the start of the print and on each layer change

[mikejtarg 0]

Hello,

 

I have been getting very good prints till recently and now at the beginning of each print on start code commands and on each layer change the print gets stuck in the same spot for about 6 seconds. This causes horrible lumps in my prints. It also adds time too. 

 

I have noticed that when it's doing this that the LCD is also unresponsive during the pausing.

 

I have attached a gcode to help identify the issue as I am out of ideas, 

 

I have reset all my settings in cura to default and I have reflashed my firmware. This has made no difference.

 

Please can anyone help?

 

 

xyzCalibration_cube.gcode

Edited March 13, 2023 by mikejtarg

[Cuq 206]

As the Code is correct, certainly an issue with Creality machine and Code M117 ask @GregValiant.