Jump to content

Inner Wall Artifacts Amplified Using Cura 5.3

jcascella

By jcascella
in Improve your 3D prints

 Share

Recommended Posts

jcascella

jcascella 0

Posted
Posted (edited) · Inner Wall Artifacts Amplified Using Cura 5.3

Using Cura 5.3, when printing more than one wall, I get strange artifacts on the first inside wall printed at the seam. So, when printing a square, it's the first wall printed from the Z seam. I can see this ever so slightly running Cura 4.10 but with 5.3 the problem is much more noticeable. With certain filaments (PETG) it's much worse.

 

Under 'Walls' I'm unable to find any setting that affects it one way or the other. None of the Z Seam positions or options change it. In Cura 4.10, I don't have any Z Seam options enabled. 

 

While it's not preventing me from printing, if I can dial it out I'd like to. Suggestions appreciated.

 

PLA, FLSun Q5, Cura 5.3, Draft profile.

 

20230325_155401.jpg

Cura Walls.jpg

Edited by jcascella
    • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share
    Go to topic listing

    • Our picks

      • Introducing the UltiMaker Factor 4

        Introducing the UltiMaker Factor 4

        ArunC posted a topic in UltiMaker 3D printers,

        We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
          • Thanks
          • Like
        • 3 replies
        MariMakes

        Picked By

        MariMakes,
      • UltiMaker Cura 5.7 stable released

        UltiMaker Cura 5.7 stable released

        ArunC posted a topic in UltiMaker Cura,

        Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more. 
         
          • Like
        • 26 replies
        MariMakes

        Picked By

        MariMakes,
      View All
    ×
    ×
    • Create New...