UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Interestingly, this is the fourth or so post I see about this in a single week, and this has not changed since Cura 2. Why is "everybody" suddenly trying to do this?
In the Cura 5.8 stable release, everyone can now tune their Z seams to look better than ever. Method series users get access to new material profiles, and the base Method model now has a printer profile, meaning the whole Method series is now supported in Cura!
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
Recommended Posts
ahoeben 1,981
See the setting "Remove empty layers".
Interestingly, this is the fourth or so post I see about this in a single week, and this has not changed since Cura 2. Why is "everybody" suddenly trying to do this?
Link to post
Share on other sites
19SeBB88 0
Thanks for response. This was the setting I was looking for.
I needed it to avoid a thin curved survace directly in contact with bed.
Link to post
Share on other sites