Using same material on both nozzles (S7) but with different Layer-Hights within same job

[zhawZPP 0]

Hi there

 

Is it possible to use both nozzles on a S7, one 0.8mm and one 0.4mm Nozzle, both set up with f.e. Nylon but with different layer-heights? We would like to print severel parts in one job, some of the parts designated to the 08nozzle, some of them to the 04 Nozzle...

 

Many thanks in advance!

 

[ahoeben 2,010]

2 hours ago, zhawZPP said:

Is it possible to use both nozzles on a S7, one 0.8mm and one 0.4mm Nozzle, both set up with f.e. Nylon but with different layer-heights?

No, that is not possible.