In this stable release, Cura 5.3 achieves yet another huge leap forward in 3D printing thanks to material interlocking! As well as introducing an expanded recommended print settings menu and lots of print quality improvements. Not to mention, a whole bunch of new printer profiles for non-UltiMaker printers!
Are you a fan of tree support, but dislike the removal process and the amount of filament it uses? Then we would like to invite you to try this special release of UltiMaker Cura. Brought to you by our special community contributor @thomasrahm
We generated a special version of Cura 5.2 called 5.3.0 Alpha + Xmas. The only changes we introduced compared to UltiMaker Cura 5.2.1 are those which are needed for the new supports. So keep in mind, this is not a sneak peek for Cura 5.3 (there are some really cool new features coming up) but a spotlight release highlighting this new version of tree supports.
In general, for such problems, search for 'under-extrusion'.
I'm not entirely sure what you mean here: Is it just the first layer and was this printed sideways, or is this through the entire model? If it's just the first layer, then there are a bunch of settings that only influence those. You can find those by searching for 'initial layer' in the custom settings.
Otherwise, if the exact model came out fine before, then it's likely to be a hardware issue. For example, the material might be slipping when it's extruded.
Link to post
Share on other sites