-
Our picks
-
UltiMaker Cura 5.8 beta released
ArunC posted a topic in UltiMaker Cura,
Another Cura release has arrived and in this 5.8 beta release, the focus is on improving Z seams, as well as completing support for the full Method series of printers by introducing a profile for the UltiMaker Method.-
- 1 reply
Picked By
MariMakes, -
-
Introducing the UltiMaker Factor 4
ArunC posted a topic in UltiMaker 3D printers,
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications-
- 3 replies
Picked By
MariMakes, -
-
Recommended Posts
GregValiant 1,330
Yes you can, but it's a pain and there are a lot of different files that need to get copied over.
You are probably better off using the Ender 3 Pro definition and then making changes to whatever Cura settings are different for the S1.
Looking at the S1 definition in 5.3.1 - the only difference I see is that the S1 is 270mm tall while the regular 3Pro is 250.
You can install a regular 3 Pro and then go to "Settings/Printers/Manage Printers" and then "Machine Settings" and change the "Z(height)" setting to 270.
You can rename any printer to whatever you like.
Link to post
Share on other sites