UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
In this print print orientation it isn't possible to fully remove the stair effect as the nozzle tip is not in in the same angel as your model surface.
You can minimize the effect by reducing the layer height at the cost of a much longer printing time.
An other, maybe better way is to lay down the model to the flat surface if you need a decent flat surface.
The third option is to place the model on an angle at the bed at the cost of a needed support structure and higher printing time.
1
Link to post
Share on other sites
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
The full stable release of UltiMaker Cura 5.4 is here and it makes it easier than ever to remove brims and supports from your finished prints. UltiMaker S series users can also look forward to print profiles for our newest UltiMaker PET CF composite material!
Recommended Posts
DivingDuck 94
In this print print orientation it isn't possible to fully remove the stair effect as the nozzle tip is not in in the same angel as your model surface.
Link to post
Share on other sites