- Solution
They have been updated as of a few hours ago, you can find them here.
https://support.makerbot.com/s/article/1667410781982
Its a small update, but the primary note is that ER80 is no longer a error that fails your print.
-
Our picks
-
UltiMaker Cura 5.8 Stable released 🎉
MariMakes posted a topic in UltiMaker Cura,
In the Cura 5.8 stable release, everyone can now tune their Z seams to look better than ever. Method series users get access to new material profiles, and the base Method model now has a printer profile, meaning the whole Method series is now supported in Cura!-
- 5 replies
Picked By
MariMakes, -
-
Introducing the UltiMaker Factor 4
ArunC posted a topic in UltiMaker 3D printers,
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications-
-
- 4 replies
Picked By
MariMakes, -
-
Recommended Posts
PizzaTijd 14
Our printer doesn't even see this new firmware yet. Probably just means you installed it the second it was released.
The patch notes always tend to lag behind a bit- they'll most likely be posted very soon.
Link to post
Share on other sites