- Solution
They have been updated as of a few hours ago, you can find them here.
https://support.makerbot.com/s/article/1667410781982
Its a small update, but the primary note is that ER80 is no longer a error that fails your print.
They have been updated as of a few hours ago, you can find them here.
https://support.makerbot.com/s/article/1667410781982
Its a small update, but the primary note is that ER80 is no longer a error that fails your print.
Recommended Posts
PizzaTijd 14
Our printer doesn't even see this new firmware yet. Probably just means you installed it the second it was released.
The patch notes always tend to lag behind a bit- they'll most likely be posted very soon.
Link to post
Share on other sites