-
Our picks
-
UltiMaker Cura 5.4 stable released
ArunC posted a topic in UltiMaker Cura,
The full stable release of UltiMaker Cura 5.4 is here and it makes it easier than ever to remove brims and supports from your finished prints. UltiMaker S series users can also look forward to print profiles for our newest UltiMaker PET CF composite material!-
-
- 58 replies
.thumb.jpeg.0b7a05eafc09add17b8338efde5852e9.jpeg)
Picked By
MariMakes, -
-
.thumb.jpeg.0b7a05eafc09add17b8338efde5852e9.jpeg)
Recommended Posts
GregValiant 1,112
Use a hair blow dryer and start warming up that mess. Gently worry at it with a pair of needle nose pliers.
Save the area with the wiring for last. Having to fix the wiring would be worse than the ball of plastic.
Patience is a virtue. Go slow. It's better to walk away for a while than to break something expensive.
Link to post
Share on other sites