not able to print

[ericloos 0]

I have a ultimaker 2+connect and i use cura for printing.

In cura i see a perfect model of my project even after slicing.

 

I read the file into my Ultimaker and the printer starts printen my model. But the is no filament  comming out of the nozzel.

I tested the ultimaker by "move the material" and yes de filament is comming out of the nozzel.

 

But when ik start printing again, the nozzel is cold, even the printerbed.

 

Who can help me out?

 

Eric 

[DivingDuck 105]

W/o further information it's quite difficult to give any useful help. Check your gcode file. Maybe the file and/or the sd card are corrupt or something had interrupted the output process for the gcode.

 

[Slashee_the_Cow 457]

It could also be hardware problem with the printer. I've seen some motherboards fail in weird, weird ways.